General Precautions - Kubota Z400-B Handbuch

[3] GENERAL PRECAUTIONS
SGOOFOOJ
[AJ IB)
• During disassembly, carefully arrange removed parts in
a clean area to prevent confusion later. Screws, bolts and
nuts should be replaced in their original posi-tion to
prevent reassembly errors.
• When special tools are required, use Kubota's genuine
special tools. Special tools which are not frequently
used should be made according to the drawings provided.
• Before disassembling or servicing live wires, make sure
to always disconnect the grounding cable from the battery
first.
• Remove oil and dirt from parts before measuring.
• Use only Kubota genuine parts for parts replacement
to maintain engine performance and to ensure safety.
• Gaskets and a-rings must be replaced during reassemb ­
ly. Apply grease to new a-rings or oil seals before assembl­
ing.
• When reassembling external snap or internal rings, position
them so that the sharp edge faces against the direction
from which force is applied.
• Be sure to perform run-in the serviced or reassembled
engine. Do not attempt to give heavy load at one, or
serious damage may result to the engine.
(1) Grease
(2) Force
(3) Place the Sharp Edge against the Direction of Force
[A] External Snap Ring
[B] Internal Snap Ring
8-3