Starter [V800-B]; Checking; Disassembly And Assembly - Kubota Z400-B Handbuch

--
[2] STARTER [V800·B]
CHECKING
Motor Test
1. Disconnect the connecting lead from the "C" terminal of
the starter and connect a jumper lead from the connecting
lead to the positive battery terminal.
2. Connect a jumper lead momentarily between the starter
body and the negative battery terminal.
3. I f the motor does not run, check the motor.
DISASSEMBLY AND ASSEMBLY
...
0107PV85
Solenoid Switch
1. Disconnect the connecting lead from the "C" terminal of
the starter.
2. Connect jumper leads from the negative terminal of 6V
battery to the body and HC" terminal of the solenoid
switch.
3. The pinion gear should pop out, when a jumper lead is
connected between the positive terminal of the battery
to the "S" terminal of the solenoid switch.
4. The pinion gear should stay out without the jumper from
the negative terminal to the "C" terminal.
• NOTE:
• Each test should be carried out for a short time, about 3
to 5 seconds.
Motor
1. Remove the con necti ng lead (1).
2. Remove the two through bolts which tighten the motor
(2) and the solenoid switch (3).
3. Detach the motor.
(1) Connecting Lead
(2) Motor
(3) Solenoid Switch
S·143