Injection Pump And Levers - Kubota Z400-B Handbuch

[3]
INJECTION PUMP AND LEVERS
Injection Pump and Speed Control Plate
1. Remove the socket headed screws and nuts, and remove
the injection pump
(3).
2.
Remove the screws and separate the speed control plate
(2), taking care not to harm the spring (4).
3. Disconnect the spring (4) and remove the speed control
plate (21.
(When reassembling)
• Hook the spring
(4)
to the lever first and install the speed
control plate
(2).
• Be sure to place the copper washers underneath two
screws
(1
)(See photo
J.
• Slide the control rod
(6)
until its end is flush with the
pump housing (See photo).
• Position, the slot
(7)
on the fork lever just under the slot
on the crankcase.
• Insert the injection pump so that the control rod (6)
should be pushed by the spring
(5)
at its end and the pin
(8) on the rod engages with the slot (7) on the fork lever
(See photo).
9.81 to 11.28 N'm
torque Injection pump 1.00 to 1.15 kgf' m
7.23 to 7.32 ft·lbs
' - - -
.. ---~
....
--~-
...
---'---.-~--- .. ~--'.--
...
- -
...
(1)
Screws and Copper Washers
(2) Speed Control Plate
(3) Injection Pump
(4)
Spring
(5)
Spring
(6)
Control Rod
(7)
Slot
(8) Pin
S·71