Kubota Z400-B Handbuch Seite 159

-
- - - - - - - - - ---------------
Gear and Camshaft
1. Remove the screws (3) and draw out the camshaft (4)
with the gear on it.
2. Remove the retaining plate (11.
3. Remove the screws (5) and draw out the fuel camshaft
(2) with the governor fork assembly.
(When reassembling)
• Hook the spring to the fork lever 2 (7) as shown in the
figure before installing the fork lever assembly to the
crankcase.
• I nstall the fork lever assembly so that the pins (9) on the
fork lever 1 (6) position evenly apart from the governor
sleeve (10) and make sure that the fork lever 1 is kept
apart from the rod plate (8) more than 1.5 mm (0.059 in.).
(1 ) Retaining Plate
(2) Fuel Camshaft
(3) Screw
(4)
Camshaft
(5) Screw
(6) Fork Lever 1
(7)
Fork Lever 2
(8) Rod Plate
(9) Pin
(10) Grovernor Sleeve
S-77