Flywheel
L I nstall the stopper to the flywheel so that the flywheel
does not turn.
2.
Remove the screws and the flywheel.
(When reassembling)
• Place the flywheel washer on the flywheel and install
them to the crankshaft, noting the location of the holes .
.---------T---------,···---····---~
53.9 to 58.8 N·m
Tightening torque
Flywheel screw
5.5 to 6.0 kgf'm
39.8
to
43.4
ft-Ibs
I
I
[5] TIMING GEARS AND CAMSHAFTS
OlOYP018
• If it is required to check the gear backlashes, measure
them before disassemby.
Idle Gear
1.
Remove the retaining ring, the thrust washers and the idle
gear (1 ).
(When reassembling)
• Install the idle gear, aligning the marks on the gears re
ferring to the figure.
(1) IdleGear
\,
/'
5-75