Kubota Z400-B Handbuch Seite 215

DISASSEMBLY AND ASSEMBLY
OlO9PUJ8
OI09P()39
Solenoid Switch
1. Remove the screws (3) to separate the solenoid switch.
2. Pull out the plunger (2) and the spring (1)'
(1) Spring
(2) Plunger
(3) Screw
End Frame
1. Remove the through bolts (3) and the screw (2).
2. Remove the rear end frame.
3. Lift the brush and remove the brush holder( 1).
4. Remove the yoke assembly.
• NOTE:
• Do not miss the thrust washers behind the commutator.
(1) Brush Holder
(2) Screw
(3) Through Bolt
Armature
1. Pullout the armature.
2. Remove the plate (1) and the lever (2).
(When reassembling)
• Install the lever, noting its direction (See photo).
• NOTE:
• Do not miss the thrust washers on the front of the
armature shaft.
(1) Plate
(2) Lever
S-133