Kubota Z400-B Handbuch Seite 227

Brush Holder
1. Remove the end frame.
2. Draw out the brushes from each holder while lifting the
spring up.
3. Remove the brush holder (1).
• NOTE:
• Do not damage the brush, commutator and bearing:
(1) Brush Holder
OlO7P086
Armature
1. Draw out the armature (2) from the yoke (1).
• NOTE:
• Do not damage the bearing and do not let the dust or oil
adhere to it.
(1) Yoke
(2) Armature
O107P087
Housing, Idle Gear and Overrunning Clutch
1. Remove the housing (3).
2. Remove the idle gear (1) and the overrunning clutch (2).
• NOTE:
• Do not damage the clutch bearing and do not let the dust
adhere to it.
• Do not lose the steel ball in the overrunning clutch.
(1) Idle Gear
(2) Overrunning Clutch
(3) Housing
Plunger
1. Remove the end cover (1) of solenoid switch (4).
2. Remove the plunger (2) and spring (3).
(1) End Cover
(2) Plunger
(3) Spring
(4) Solenoid Switch
(}1071'O89
S-145