Crankshaft And Piston - Kubota Z400-B Handbuch

Oil Seal Sleeve and Gear
1. Pull out the oil seal sleeve (2) together with the gear (1)
using a gear puller.
(When reassembling)
• Install the idle gear before installing the sleeve (See figure
at "Idle Gear").
• Be sure to place the O-ring (3) before installing the sleeve
(2).
(1)
Gear
(2) Oil Seal Sleeve
(3) O-ring
[6] CRANKSHAFT AND PISTON
Main Bearing Case Cover
1. Remove the screws, and lift the cover (1) by screwing two
screws (See photo) gradually and evenly.
(When reassembling)
• Place the case cover and the gasket noting each direction
(See photo), and tighten the screws.
·
9.81 to 11.28 N'm
Main bearing
Tighten i ng torque
1 .00 to 1 .15 kgf· m
case screw
7.23
to
8.32
ft-Ibs
I
(1) Main Bearing Case Cover
(A) To lift the cover, screw in two screws.
8-79