Kubota Z400-B Handbuch Seite 247

Rotor
1. With the drive end frame held level on the blocks as
illustrated, press out the rotor.
• IMPORTANT:
• Take special care not to drop the rotor and damage the
slip ring or fan, etc.
(1)
Press (3) Block
(2) Rotor (4)
Drive End Frame
Retainer Plate
1.
Remove the four screws holding the retainer plate and
remove the retainer plate,
4
Bearing on the Drive End Side
--~.-.~.---~.~--
1.
With the drive end frame held level on blocks as illustrated,
extract the bearings with a press and jig .
• IMPORTANT:
• Two bearings for high-speed rotation are used. When re­
placing them with new ones, be sure to use genuine parts
readily identified by the part number indicated. Also, take
care not to strike the bearing.
(1) Press (3) Block
(2) Jig (4) Drive End Frame
()I 1i9j';'i/.'
Bearing at the Slip Ring Side
1. Using a puller, extract the bearing in the manner shown in
the figure.
(1) Lightly secure with a vise to
prevent damage
(2) Press at the center
5-165