Disassembly And Assembly - Kubota Z400-B Handbuch

DISASSEMBLY AND ASSEMBLY
O109P304
~,!lIey
1. With the hexagonal end of the pulley shaft secured with a
double-ended ratchet wrench as shown in the photo,
loosen the pulley nut with a socket wrench and remove it.
• IMPORTANT:
• Be sure to use hexagonal socket wrench; if a dodecagonal
socket wrench is used, the hexagonal head of the pulley
shaft may be damaged and cause the wrench to slip.
Rear End Cover
OI09P305
1. Unscrew the three rear end cover screws and the terminal
"8" nut and remove the rear end cover.
(1) Screws
(2) Rear End Cover
(3) Terminal "8" Nut
O109P306
Brush Holder
1. Unscrew the two screws holding the brush holder and the
rectifier and remove the brush holder.
(1) B rush Holder
S·161