Gear Case And Flywheel - Kubota Z400-B Handbuch

[4] GEAR CASE AND FLYWHEEL
20 (0.79)
.......
~
..
-
o
(0.39) dia.
'Unit: mm (in.)
Pul~y an~ Gear Case
1. Prepare the stopper (See figure) and install it to the
flywheel so that the crankshaft does not turn.
2. Flatten the metal lock and remove the lock screw and pull
out the pulley with a puller.
3. Remove the screws and disconnect the spring, and remove
the gear case.
• NOTE:
• Be sure to remove the bolts behind the fan and inside the
gear case, (1) and (2).
(When reassembling)
• Be sure to tighten the screws
(1)
and (2), and hook the
spring (3).
• Install the pulley to the crankshaft, aligning the marks (4)
on them. (except V800·B)
Apply engine oil to the lock screw and tighten it to the
specified torque.
Tightening torque
Gear case
(1) Screw
(2) Screw
(3) Spring
(4) Aligning Mark
S·73