Bosch Performance Line SX Drive Unit Originalbetriebsanleitung Seite 569

English – 4
Operation
The Bluetooth® button (1) has various functions. If the on-
board computer was connected with an operating unit and
has been removed from the holder, the displays can be
switched within 60 s. To do so, briefly press the
Bluetooth® button (1). The on-board computer is then set to
stand-by mode.
Note: If you are not going to be using your eBike for several
months, remove the on-board computer from its holder and
set the on-board computer to storage mode. To do this,
press the Bluetooth® button (1) until <Storage Mode?> ap-
pears.
To deactivate storage mode, switch the eBike on and press
the Bluetooth® (1) button for 3 seconds. The display shows
confirmation that the eBike is connected to the on-board
computer.
The reset button (5) serves to reset the on-board computer
to factory settings and delete all connections.
The on-board computer can be operated using one of the op-
erating units shown. The functions of the buttons on the op-
erating units can be found in the following overview.
Depending on how long it is pressed for, the select button
has 2 functions.
5-button operating unit
Scroll to the left
Scroll to the right
Increase assistance level
Decrease assistance level
Select button (press briefly)
Select button/open menu (press and hold > 1 s)
3-button operating unit
Increase assistance level
0 275 007 3BI | (23.02.2024)
Decrease assistance level
Select button/scroll through the screens (press
briefly)
Select button/open menu (press and hold > 1 s)
Note: All screenshots showing the display and text on the
following pages are from the approved software version. The
display, text and/or functions may change following a soft-
ware update.
Note: Depending on the lighting conditions, there is back-
ground lighting that is only activated by pressing a button.
The lighting duration can be adjusted.
Displays and settings of the on-
board computer
Speed and distance indicators
The speedometer always displays the current speed.
You can choose from the following functions in the function
display (combination of text indicator and value indicator):
– <Distance>: Distance travelled since the last reset
– <Riding time>: Journey time since the last reset
– <Time>: Current time
– <Range>: Estimated range of the eBike's available bat-
tery charge (at constant conditions such as riding mode,
route profile, etc.)
– <Avg. Speed>: Average speed achieved since the last re-
set
– <Max. Speed>: Maximum speed achieved since the last
reset
– <Total distance>: Total distance travelled with the eBike
(cannot be reset)
Note: The on-board computer automatically displays a gear
change recommendation when riding the eBike. The display
of the gear change recommendation is superimposed over
the text display (f) of the on-board computer, and can be de-
activated manually via the basic settings.
Switching in the Function Indicator
Press the or button until the required
function is displayed.
Press the select button repeatedly until the
required function is displayed.
Certain settings cannot be applied on the on-board com-
puter, but only in the eBike Flow app, e.g.:
– <Wheel circumference>
– <Reset range calculation>
– <Auto trip reset>
In addition, you receive an overview of the operating hours
and the installed components in the eBike Flow app.
Bosch eBike Systems