Trim For The Steering Function, "St-Trim" Knob; Gyro Sensitivity Or Dual Rate For Steering Function, "Gyro Lv / St-D/R" Knob; Steering Function Reversal, "St" Slide Switch; Trim For The Drive Function, "Th-Trim" Knob - Reely Deathwatcher XL Bedienungsanleitung

11.6 Trim for the steering function, "ST-TRIM" knob

If the vehicle tends to pull to the left or right while driving, even though the steering wheel is in the middle position, set
the steering trim accordingly with the "ST-TRIM" knob on the transmitter (see fig. 1, no. 9).
During the adjustment, one of the LEDs (fig. 1, no. 13) indicates the trim position, and the LED
display changes back to the battery status if the knob is not moved for approx. 5 seconds.

11.7 Gyro sensitivity or dual rate for steering function, "GYRO LV / ST-D/R" knob

The "GYRO LV / ST-D/R" knob (fig. 1, no. 11) has two different functions depending on whether the receiver gyro is
enabled or disabled.
11.7.1 Gyro is enabled
The "GYRO LV / ST-D/R" knob (fig. 1, no. 11) allows changing the gyro sensitivity. More details can be found in sec-
tion 12.
11.7.2 Gyro is disabled
The "GYRO LV / ST-D/R" knob (fig. 1, no. 11) allows limiting the maximum steering angle, thus improving the vehicle
steering performance during fast driving, as it responds more sensitively.
During the adjustment, one of the LEDs (fig. 1, no. 13) indicates the setting, and the LED display
changes back to the battery status if the knob is not moved for approx. 5 seconds.
Attention!
If you turn the knob all the way to the left, you will not be able to move the steering
servo. Hence, you will not be able to steer the vehicle.

11.8 Steering function reversal, "ST" slide switch

Use the "ST" slide switch (fig. 1, no. 14) to reverse the steering servo movement direction (e.g. when holding the
transmitter with your right hand and steering with your left hand).

11.9 Trim for the drive function, "TH-TRIM" knob

If the vehicle does not stop when you release the throttle lever for forward/reverse travel (middle/neutral position), set
the trim for the drive function accordingly on the transmitter with the "TH-TRIM" knob (see fig. 1, no. 2).
During the adjustment, one of the LEDs (fig. 1, no. 13) indicates the trim position, and the LED
display changes back to the battery status if the knob is not moved for 5 seconds.
56