Reely Deathwatcher XL Bedienungsanleitung Seite 78

Pull the throttle lever on the transmitter as far as it will go to the handle (= full throttle forward), then move it back
to the middle (neutral) position. The drive does not start while doing so.
Push the throttle lever away from the handle as far as it will go (= full throttle reverse), then move it back to the
middle (neutral) position. The drive does not start while doing so.
Turn the steering wheel on the transmitter clockwise all the way to the left, then move it back to the middle (neutral)
position. The steering moves as usual.
Turn the steering wheel clockwise all the way to the right, then move it back to the middle (neutral) position. The
steering moves as usual.
The transmitter LED will flash three times and then light up permanently.
If the LED does not flash three times, make sure to check the EPA setting and the position of the two knobs
(see instructions for the pairing function) and set them correctly.
Briefly check the vehicle function to see if it responds correctly to the transmitter control signals (steering and
motor/drive).
You can now enable or disable the gyro as needed. Please refer to section 12.1.
Turn off the speed controller and then the transmitter.
Put the receiver back into the receiver box. The receiver must be positioned horizontally, with the sockets/plugs
facing upwards, and the lateral orientation is irrelevant. Guide the antenna cable out of the receiver box. Stow the
remaining cables in the receiver box and close it again, taking care not to pinch any cables when screwing it shut.
Now you can turn on the transmitter again and operate the vehicle.
78