Programming The Transmitter; A) Reverse Function For The Steering Servos; B) Reverse Function For The Speed Controller - Reely Rockcrawler Bedienungsanleitung


11.

Programming the Transmitter

The transmitter offers several other functions that are already pre-set to match the vehicle ex works. If required,
however, you can perform corrections or changes of the programming.
The following functions can be programmed:
• Reverse rotating direction of the steering servo at the front axle (reverse for channel 1)
• Reversing reaction of the speed controller to the operating lever (reverse for channel 2)
• Dual rate for steering servos
• Dual rate for forwards/reverse driving
• EPA settings for steering servo of the front axle (limit steering angle)
• EPA settings for forwards/reverse driving (limit speed)
Select the desired function by pressing the button "SEL" (5). The displayed value can be changed with the
rocker button "DT1" (12). If no button is pressed for approx. 5 seconds, the transmitter leaves setting mode
and returns to normal display/function.

a) Reverse Function for the Steering Servos

• Press the button "SEL" (5) repeatedly until "CH1 NOR" or "CH1 REV" is
displayed.
• Switch between "NOR" and "REV" with the rocker button "DT1" (12) (reverse
function for the steering servos). The running direction of the two steering
servos reverses.
• Press the button "SEL" (5) to get to the next setting function.
If no button is pressed for 5 seconds, the transmitter leaves setting mode
automatically and returns to normal display/function.

b) Reverse Function for the Speed Controller

• Press the button "SEL" (5) repeatedly until "CH2 NOR" or "CH2 REV" is
displayed.
• Switch between "NOR" and "REV" with the rocker button "DT1" (12) (reverse
function for cannel 2). This reverses the speed controller reaction to the
movement direction of the lever for the driving function (10).
• Press the button "SEL" (5) to get to the next setting function.
If no button is pressed for 5 seconds, the transmitter leaves setting mode
automatically and returns to normal display/function.
38