Programming The Speed Controller; Adjusting The Neutral And Full Throttle Setting - Reely Deathwatcher XL Bedienungsanleitung

15 Programming the speed controller

15.1 Adjusting the neutral and full throttle setting

If the vehicle does not stay stationary when the throttle/brake lever is in the neutral position, the throttle trim can be
adjusted on the transmitter.
If the trim setting is insufficient (or if the trim is almost in the end position), you can re-program the neutral and full
throttle positions for driving forwards and backwards.
Proceed as follows:
Turn off the speed controller and the transmitter.
Place the vehicle on a stable surface so that the wheels can turn freely.
Turn on the transmitter and leave the throttle in the neutral (middle) position. Set the trim for the drive function to
the neutral position.
Keep the setup button (B) pressed and switch on the speed controller by
pressing the on/off switch (A) as usual.
The LED on the speed controller will then flash red and the engine will emit
beeps. Release the setup (B) button.
Unless you release the setup button, the programming mode will be acti-
vated after a few seconds (see section 15.2). In this case, turn off the speed
controller and proceed again as described above.
Beeps are generated by a brief activation of the brushless motor. This beep can be very quiet depending
on the engine. If this is the case, note the LEDs indication on the speed controller.
Release the transmitter throttle lever so that it is in the neutral (middle) position.
If you press the setup button (B) briefly, the LED on the speed controller will flash green once briefly and you will
then hear a beep. The neutral position has been saved.
Move the throttle lever to the full forward throttle position (move it towards the handle and hold it in place).
Attention!
If you do not move the transmitter throttle lever during the programming process or do not move it far
enough, the vehicle might respond to even slight movements of the transmitter throttle lever or become
uncontrollable. In this case, reprogram it.
If you press the setup button (B) briefly, the LED on the speed controller will flash green twice briefly and you will
then hear two beeps. The full forwards throttle position will be saved.
Move the throttle lever to full reverse throttle by pushing it away from the handle as far as it will go.
If you press the setup button (B) briefly, the LED on the speed controller will flash green thrice briefly and you will
then hear three beeps. The full reverse throttle position will be saved.
Releasing the throttle lever takes it to the neutral (middle) position. The flashing green LED on the speed controller
and the corresponding beeps indicate the cell count (see section 14.5).
Wait for at least three seconds. The speed controller will automatically exit settings mode and apply the new
settings.
68
Figure 6