Reely Deathwatcher XL Bedienungsanleitung Seite 66

Discontinue use immediately if the vehicle does not respond as expected, or if the vehicle stops responding to
the transmitter commands. This behaviour could be caused by a weak drive battery, low batteries/rechargeable
batteries in the transmitter or too great a distance between the vehicle and the transmitter.
Disturbances on the radio channel used (e.g. other models, radio transmissions from other devices, Bluetooth
Wi-Fi) or adverse transmission/reception conditions could also be a cause for unusual vehicle responses.
If the drive batteries are empty, be sure to wait at least 5 to 10 minutes until the motor and the speed controller
have cooled down sufficiently. Then, start driving again with fully charged drive batteries.
The following images are for reference purposes only and do not necessarily correspond to the design of
the transmitter included with the product!
Use the throttle lever to control forward and reverse travel and the motor brake as follows:
– Release the throttle lever (move it to the neutral position); the vehicle should roll to a halt or stay stationary (if
necessary, adjust the trim for the drive function on the transmitter).
– Drive forward, slowly pull the throttle towards the handle
– Move the throttle lever away from the handle at one stroke to cause the vehicle to move forward and brake
(the vehicle decelerates quickly rather than coming slowly to a standstill).
– Move forwards, brake and then drive in reverse: Push the throttle lever away from the handle (braking) at one
stroke; when the vehicle is stationary, move the throttle lever to the neutral position briefly (approx. 1 second),
then push the throttle lever away from the handle (the vehicle will now reverse).
Forward
66
Brake
(motor brake)
When the vehicle is
stationary, wait for a
moment
(1 second)
,
®
Reverse