Trim Function For Forward/Reverse Travel; Trim Function Parts For Steering; Reverse Setting For Steering; Stopping The Vehicle - Reely Adventure Bedienungsanleitung

12.8 Trim function for forward/reverse travel

If the vehicle does not stop when you release the throttle/brake lever for forward/reverse travel (middle/neutral posi-
tion), set the trim for the driving function accordingly on the transmitter with the "TH.TRIM" knob (see chapter 11, item
9).

12.9 Trim function parts for steering

If the vehicle tends to pull to the left or right while driving, even though the steering wheel is in the middle position, set
the steering trim accordingly with the "ST.TRIM" knob on the transmitter (see chapter 11, item 10).

12.10 Reverse setting for steering

If you turn the steering wheel to the left (counter-clockwise), the vehicle must turn to the left. If the vehicle drives
exactly in the opposite direction, move the reverse switch "ST" (see chapter 11, item 11) to the other position.

12.11 Stopping the vehicle

To stop the vehicle, proceed as follows:
Release the throttle/brake lever on the transmitter so that it is in the neutral position, and then let the vehicle coast
to a standstill.
When the vehicle is stationary, switch it off using the on/off switch on the underside (switch position "OFF" =
switched off).
Attention!
Do not reach into the wheels or drive or move the throttle/brake lever on the transmitter! Do not hold the
vehicle by the wheels!
The motor, speed controller and drive battery become very hot during use! Do not touch these parts im-
mediately after use – burn hazard!
Disconnect the drive battery from the vehicle. Remove the plug completely.
Then turn off the transmitter.
35