Resetting The Speed Controller - Reely Deathwatcher XL Bedienungsanleitung

15.3 Resetting the speed controller

Use this function to reset all configured settings to the factory defaults.
Proceed as follows:
Turn off the speed controller and the transmitter.
Place the vehicle on a stable surface so that the wheels can turn freely.
Switch on the transmitter. Leave the throttle lever in the neutral position and do not move it.
Use the on/off switch (A) to turn the speed controller on as usual.
Keep the setup button (B) pressed until the red and green LEDs on the
speed controller start to flash slowly at the same time.
Now turn off the speed controller. All settings will be reset to the factory
defaults.
Next, configure the neutral position and the full forward and reverse throttle
positions as described in section 15.1, as these are also erased during
the reset.
Finally, re-configure the speed controller as described in section 15.2.
Figure 8
71