C) Testing Of Steering Function With The Help Of Transmitter - Reely RHINO Bedienungsanleitung

Now guide the linkage rods thought the drilling of
the holding pin on the servo saver and secure the
rods with a grub screw, that is screwed into the hold-
ing pin from the top with the help of a 1.5 mm Allen
key.
Before you fasten the grub screw, use the remote
control transmitter and the steering servo again.
Afterwards check the trim on the transmitter and the
correct setting of the lever on the steering servo.
Now both front wheels are aligned precisely to the
direction of driving and afterwards the grub screws
are tightened carefully.

c) Testing of steering function with the help of transmitter

If the front wheels are turning left although you steered towards the right on the transmitter, you have
to change the direction of steering of the steering servo with the servo reverse function on the remote
control transmitter.
If the steering on the vehicle already responds strongly to a slight steering on the transmitter, choose a
steering point for the steering rods that is further on the inside on the lever of the steering servo.
Our tip:
Always try to set the mechanics optimally first before you limit the servo path electroni-
cally with transmitter functions such as end point adjustment (EPA) or dual rate (D/R).
Illustration 6
37