Symbols Used In This Document; Scope Of Delivery - Grundfos Multilift M Montage- Und Betriebsanleitung

English (GB) Installation and operating instructions
Original installation and operating instructions
CONTENTS
1. Symbols used in this document
2. Scope of delivery
3. General description
3.1 Applications
4. Transportation and storage
5. Product description
5.1 Lifting station
5.2 LC 221 controller
6. Operating LC 221 controller
6.1 Description of display
6.2 Setup menu
6.3 Information menu
6.4 Description of fault indications
7. Installation of lifting station
7.1 General description
7.2 Guidelines for installation of lifting station
7.3 Procedure for installation of lifting station
8. Installation of LC 221 controller
8.1 Location
8.2 Mechanical installation
8.3 Electrical connection
8.4 Setting of LC 221
8.5 Wiring diagrams
9. Startup
10. Maintenance and service
10.1 Mechanical maintenance
10.2 Motor
10.3 Electrical maintenance
10.4 Cleaning the level sensor
10.5 Contaminated lifting station or components
11. Fault finding
12. Technical data
12.1 Lifting station
12.2 LC 221 controller
13. Disposal
Warning
Prior to installation, read these installation and
operating instructions. Installation and operation
must comply with local regulations and accepted
codes of good practice.
Warning
The use of this product requires experience with and
knowledge of the product.
Persons with reduced physical, sensory or mental
capabilities must not use this product, unless they
are under supervision or have been instructed in the
use of the product by a person responsible for their
safety.
Children must not use or play with this product.
4

1. Symbols used in this document

Warning
Page If these safety instructions are not observed, it may
result in personal injury.
4
4
Warning
5
These instructions must be observed for
5
explosion-proof pumps.
5
6
If these safety instructions are not observed, it may
Caution
6
result in malfunction or damage to the equipment.
8
12
Notes or instructions that make the job easier and
Note
12
ensure safe operation.
14
15

2. Scope of delivery

16
Grundfos Multilift M lifting stations are supplied complete with
18
collecting tank, pump, level sensor, non-return valve and LC 221
18
controller. Both sensor and pump are connected to the controller
19
with a 4 or 10 m hose and cable.
19
An accessories bag containing the following items is also
21
included:
21
• 1 x installation and operating instructions
21
• 1 x Quick guide for controller menu
22
• 1 x outlet adapter flange, DN 80, with connection piece, DN
22
100 (outer diameter, 110 mm)
22
• 1 x flexible hose, DN 100, and two clamps to connect the
23
outlet pipe
24
• 1 x flexible hose, DN 70, and two clamps to connect the
24
venting pipe
24
• 2 x screw and expansion anchor for tank fixation
25
25
• 3 x screw and washer for fastening a pipe plug in the inlet disk,
25 if required
26 • 1 x socket seal, DN 100
• 1 x socket seal, DN 50, for diaphragm pump, 1 1/2" connection
28
or inlet, DN 50
28
28
• 1 x gasket kit, DN 80,
(galvanised).
28
4 bolts M16,
nuts and washers