Scheppach MTP750 Originalbetriebsanleitung Seite 47

5. Check the electrode gap and adjust it using a feel-
er gauge. To make sure that the engine remains
efficient, the spark plug must have the right elec-
trode gap (0.7 - 0.8 mm).
6. Screw the spark plug back in by hand and tighten
it about 1/4 turn with the spark plug wrench (C).
7. Connect the spark plug connector to the spark plug.
m ATTENTION!
A loose spark plug can overheat and cause damage to
the engine. If you tighten the spark plug too much, the
thread in the cylinder head may be damaged.
13.5 Pump out petrol with a petrol extraction pump
The petrol must be drained in the event of storage over
a longer period of time or for transport.
m WARNING!
Health hazard!
Inhalation of petrol/lubricating oil vapours and exhaust
gases can cause serious damage to health, uncon-
sciousness and in extreme cases death.
- Do not breathe petrol/lubricating oil vapours and
exhaust gases.
- Empty out fuel only outdoors.
1. Hold a collection bucket under the hose of the pet-
rol extraction pump (not included in the scope of
delivery).
2. Unscrew and remove the fuel tank filler cap.
3. Push the hose of the petrol extraction pump into
the fuel tank (21) and pump out the petrol com-
pletely using the petrol extraction pump.
4. Retighten the fuel tank filler cap.
13.6 Adjusting the clutch
The clutch play changes with the wear of the clutch.
To enable proper operation, the clutch cable must be
adjusted.
1. Set the clutch lever (1) to the original position using
the adjuster.
2. To do this, tighten the counternut with a 10 mm
open-ended spanneruntil the clutch engages
properly again.
13.7 V-belt tension and V-belt replacement
To do this, contact a specialist workshop.
Please provide the following information in the
event of any enquiries:
• Machine data - type plate
• Motor data - type plate
Important note in the case of repairs:
For return delivery of the device for repair, please en-
sure for safety reasons that it is free of oil and fuel when
it is sent to the service centre.
13.8 Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Device type
• Device article number
Spare parts / accessories
Petrol suction pump
Potato harvester
Plough
Iron wheel
Adjustable furrow attachment
13.9 Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Spark plugs, blades, air filter, all oper-
ating materials
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
14. Storage
m DANGER!
Risk of fire and explosion!
Storing the product near potential sources of ignition
can result in a fire or an explosion. This can lead to
severe burns or death.
- Eliminate possible sources of ignition, such as fur-
naces, hot water boilers with gas, gas dryers, etc.
NOTE!
Risk of damage!
If the product is not stored properly, the engine can be
damaged.
- Store the product protected against dirt, dust and
moisture.
www.scheppach.com
Article no.:
7907600001
7912301702
7912301703
7912301704
7912301705
GB | 47