HP CM8060 Color MFP Kundendienst Handbuch Seite 1519

C7.0B50: Bonding Agent supply is empty
Initial Steps
1. Check the supply status screen for the Bonding Agent cartridge and look for the Bonding Agent level indicator.
Check for any error message or code
1. Replace the suspected empty Bonding Agent cartridge with a new Bonding Agent cartridge.
Is a message prompting you to replace the Bonding Agent cartridge displayed on the control panel?
No Yes
Check the cartridge brand
1. Verify that the Bonding Agent cartridge is an HP Bonding Agent cartridge.
1 Is the Bonding Agent cartridge an HP Bonding Agent cartridge?
1 No Yes
Check for contamination
1. Check for any moisture, Bonding Agent, or PEG on the Bonding Agent cartridge connector and surrounding area.
2. Check for any Bonding Agent off of the wire harness between the ISS PCA (A8) and the Bonding Agent cartridge
connectors.
1 2 Is there moisture, Bonding Agent, or PEG on the cartridge connector?
1 2 No
1 2 3
Check the connector pins
1. Remove the suspected Bonding Agent cartridge and check for bent pins on the Bonding Agent cartridge connector.
1 2 Are the pins bent on the Bonding Agent cartridge connector?
1 2 No
1 2 3
„Final activities" auf Seite 24
1 2
Check the administrative settings
1. Verify that the "Empty Override" setting is on for non-HP Bonding Agent.
By default, printing will not occur if the supply is non-HP Bonding Agent. Original HP Bonding Agent is needed to maintain
1
pen nozzle health.
„Final activities" auf Seite 24
DEWW
Yes
Clean the contamination as needed
1. If the problem continues, replace the Bonding Agent cartridge connector.
Yes
Repair the pins on the Bonding Agent cartridge connector
1. Remove the Bonding Agent cartridge connector and try reforming the pins. If the problem continues, replace
the Bonding Agent cartridge connector.
C7.0B50: Bonding Agent supply is empty 1453