Test the voltage to the Tray 5 Back Latch sensor (SN106) on the Tray 5 Distribution PCA (A101)
1.
Test the voltage to SN106 on A101: Tray 5 unlatched: 1.19 Vdc both blocked and unblocked at pins 8B to 6Bon W103P103-
A101J3 . Tray 5 latched: 1.0VDC at pins 8B to 6B on W103P103-A101J3 and 0.09 vdc unblocked, 4.91 vdc blocked at pins
1B to 6B on W103P103-A101J3.
„Tray 5 distribution PCA diagram" auf Seite 2282
„Tray 5 component locator" auf Seite 2363
VORSICHT!
1
Is the voltage correct?
1
No
Yes
Test the voltage at the Tray 5 Back Latch sensor (SN106)
1.
Verify that J3 is connected on the Tray 5 Distribution PCA (A101).
2.
Disconnect the wire connector from the sensor.
3.
Test the voltage at SN106: 4.96 Vdc at pins 1 to 3 and 2 to 3 on W103P112-SN106.
„Tray 5 wiring diagram" auf Seite 2281
„Tray 5 component locator" auf Seite 2363
VORSICHT!
1
2
Is the voltage correct?
1
2
No
1
2
3
Check the wire harness between the Tray 5 Distribution PCA (A101) and the Tray 5 Back Latch sensor (SN106)
1.
Check the wire harness and connections between A101 and SN106.
„Tray 5 wiring diagram" auf Seite 2281
1
2
„Tray 5 component locator" auf Seite 2363
Test the voltage to the Tray 5 Back Latch sensor (SN106) on the Motion PCA (A2)
1.
Verify that J3 is connected on the Tray 5 Distribution PCA (A101).
2.
Remove the power supply from the MFP, and then electrically reconnect the power supply outside of the MFP.
3.
Test the voltage to SN106 on A2: 3.8 Vdc on J13 pins 22 to 13, 14, 37, and 38 (GND) and 5 Vdc on pins 15 to 13, 14, 37, and
38 (GND).
„Motion PCA (A2) diagram" auf Seite 2308
VORSICHT!
1
Is the voltage correct?
No
Yes
1
1278 Kapitel 8 Hardware fault trees
Use an ESD strap.
Use an ESD strap.
Yes
Repair or replace the Tray 5 Back Latch sensor (SN106)
1.
Verify that the latch is correctly adjusted and makes contact between Tray 5 and the print engine.
2.
If the latch is working correctly, replace SN106.
„Sensoren" auf Seite 773
VORSICHT!
Use an ESD strap.
Use an ESD strap.
DEWW