HP CM8060 Color MFP Kundendienst Handbuch Seite 1417

Test the voltage to the IDO Output motor (M11) on the Motion PCA (A2)
1. Test the voltage to M11 on A2: 5 Vdc at J14 pins 3 to 12.
„Motion PCA (A2) diagram" auf Seite 2308
1 2 Is the voltage correct?
1 2 No
1 2 3
1 2 3
1 2 3
1 2 3
Replace the Motion PCA (A2)
1. Replace A2.
1 2 „Motion PCA (A2)" auf Seite 710
Test the voltage to the IDO Ouput Motor encoder (EN4) on the Motion PCA (A2)
1. Disconnect J4 on A2.
2. Test the voltage to EN4 on A2: 5 Vdc at J4 pins 10A to 12A.
„Motion PCA (A2) diagram" auf Seite 2308
1
Is the voltage correct?
No Yes
1
Test the voltage at the IDO Ouput Motor encoder (EN4)
1. Verify that J4 is connected on the Motion PCA (A2).
2. Disconnect the wire connector.
3. Test the voltage at EN4: 5 Vdc at pins 9A to 7A on W97P7-W44J7.
„IDO motors and encoders wiring diagram" auf Seite 2284
1 2 Is the voltage correct?
DEWW
Yes
Test the voltage at the IDO Output motor (M11)
1. Verify that J14 is connected to the Motion PCA (A2).
2. Disconnect the wire connector from the motor.
3. Test the voltage at M11: 5.23 Vdc at pins 1 to 2 on W19P11-M11.
„IDO motors and encoders wiring diagram" auf Seite 2284
TIPP: Click Subsystems, click Paper Path, and then click IDO Motors.
Is the voltage correct?
No Yes
Replace the IDO Output motor (M11)
1. Replace M11.
4
„IDO Output motor (M11)" auf Seite 421
Check the wire harness
1. Check the wire harness between the Motion PCA (A2) and the IDO Output motor (M11).
2. Repair as needed.
„IDO motors and encoders wiring diagram" auf Seite 2284
B2.0106: IDO Output motor (M11) stall 1351