HP CM8060 Color MFP Kundendienst Handbuch Seite 1439

B2.1301: Paper jam at IDO Input Staging 2 sensor (SN10)
Initial Steps
1. Check for obstructions in the paper path.
2. Check the condition of the paper.
„IDO component locator" auf Seite 2365
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
3. Check the horizontal transport drive rollers for excessive wear.
Test the IDO Input Staging 2 sensor (SN10)
1. Manually activate SN10.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
1 „B2.0101: IDO Input 1 motor (M8) stall" auf Seite 1334
Check the following
1. Verify that the sensor is correctly located.
2. Check the IDO printzone interface-to-horizontal transport alignment. Refer to the IDO printzone interface and horizontal transport
alignment procedure.
3. Verify that all of the idler rollers are correctly seated and that the drive roller surfaces are free of defects.
4. Clean the sensor and the surrounding area.
5. If the sensor has a flag actuator, check that the flag actuator has free movement.
6. Check the wire harness between the IDO Input Staging 2 sensor (SN10) and the Motion PCA (A2).
„IDO component locator" auf Seite 2365
Test the IDO Input Staging 2 sensor (SN10)
1. Manually activate SN10.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
1 „Final activities" auf Seite 24
DEWW B2.1301: Paper jam at IDO Input Staging 2 sensor (SN10) 1373