HP CM8060 Color MFP Kundendienst Handbuch Seite 1456

No Yes
Test the voltage at the IDO Duplex Media sensor (SN16)
1. Verify that J4 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the sensor.
3. Test the voltage to SN16: 3.24 Vdc unblocked, 0.08 Vdc blocked at pins 10B to 9B and 1.18 Vdc unblocked or blocked at pins
11B to 9B on W97P7-W44J7.
„IDO paper path 1 wiring diagram" auf Seite 2285
1 Is the voltage correct?
No Yes
1
Replace the IDO Duplex Media sensor (SN16)
1. Replace SN16.
1 2
„IDO-Sensoren" auf Seite 485
Check the wire harness
1. Check the wire harness and connections between the IDO Duplex Media sensor (SN16) and the Motion PCA (A2).
„IDO paper path 1 wiring diagram" auf Seite 2285
„Motion PCA (A2) diagram" auf Seite 2308
1 2. Repair as needed.
„D4.0705: Motion PCA (A2) power not good" auf Seite 1469
1390 Kapitel 8 Hardware fault trees DEWW