HP CM8060 Color MFP Kundendienst Handbuch Seite 1357

A2.06C1: Tray 5 Top Door LED (LED102) not lit
Initial Steps
1. „Tray 5 component locator" auf Seite 2363
Test the Tray 5 Top Door LED (LED102)
1. Activate LED102.
2. Verify that LED102 turns on and off.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the LED turn on and off?
No Yes
Check for problems that might cause intermittent behavior
1. Check the wire harness between the Motion PCA (A2) and the LED.
„Tray 5 wiring diagram" auf Seite 2281
1 2. Check the LED mounting and surrounding area for any obvious problems. Repair as needed.
Check the Tray 5 Top Door LED (LED102) and wire harness
1. Verify that the LED is correctly located.
„Tray 5 wiring diagram" auf Seite 2281
2. Check the wire harness between the Motion PCA (A2) and the LED.
„Tray 5 wiring diagram" auf Seite 2281
Test the Tray 5 Top Door LED (LED102)
1. Activate LED102.
2. Verify that the LED turns on and off.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the LED turn on and off?
No Yes
1 „Final activities" auf Seite 24
Test the voltage to the Tray 5 Top Door LED (LED102) on the Motion PCA (A2)
1. Disconnect J13 from A2.
2. Test the voltage to the LED102 on A2: 5 Vdc on J13 at pins 17 to 14.
„Motion PCA (A2) diagram" auf Seite 2308
Is the voltage correct?
No Yes
DEWW A2.06C1: Tray 5 Top Door LED (LED102) not lit 1291