HP CM8060 Color MFP Kundendienst Handbuch Seite 1404

Test the voltage to the IDO Input 2 motor (M10) on the Motion PCA (A2)
1. Test the voltage to M10 on A2: 19.2 Vdc (not using the voltage test routine) at J14 pins 2 to 11.
„Motion PCA (A2) diagram" auf Seite 2308
TIPP:
1 2 Is the voltage correct?
No
1 2
1 2 3
1 2 3
1 2 3
1 2 3
Replace the Motion PCA (A2)
1. Replace A2.
1 2 „Motion PCA (A2)" auf Seite 710
Test the voltage to the IDO Input 2 Motor encoder (EN5) on the Motion PCA (A2)
1. Disconnect J4 from A2.
2. Test the voltage to EN5 on A2: 5 Vdc at J4 pins 13B to 11B.
„Motion PCA (A2) diagram" auf Seite 2308
1
Is the voltage correct?
No Yes
1
Test the voltage at theIDO Input 2 Motor encoder (EN5)
1. Verify that J4 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the encoder.
3. Test the voltage at EN5: 5 Vdc at pins 6B to 8B on W97P7-W44J7.
„IDO motors and encoders wiring diagram" auf Seite 2284
1 2 Is the voltage correct?
1338 Kapitel 8 Hardware fault trees
Click Subsystems, click Paper Path, and then click IDO Motors.
Yes
Test the voltage at the IDO Input 2 motor (M10)
1. Verify that J14 is connected to the Motion PCA (A2).
2. Disconnect the wire connector from the motor.
3. Test the voltage at M10: 5.23 Vdc at pins 1 to 2 on W19P10-M10.
„IDO motors and encoders wiring diagram" auf Seite 2284
TIPP: Click Subsystems, click Paper Path, and then click IDO Motors.
Is the voltage correct?
No Yes
Replace the IDO Input 2 motor (M10)
4
1. Replace M10.
Check the wire harness
1. Check the wire harness between the Motion PCA (A2) the IDO Input 2 motor (M10).
2. Repair as needed.
„IDO motors and encoders wiring diagram" auf Seite 2284
DEWW