HP CM8060 Color MFP Kundendienst Handbuch Seite 1329

Replace the Tray 5 Pick Motor encoder (EN101)
1 2 1. Replace EN101.
Check the wire harness between the Tray 5 Distribution PCA (A101) and the Tray 5 Pick Motor encoder (EN101)
1. Check the wire harness between A101 and EN101.
1
„Tray 5 wiring diagram" auf Seite 2281
Test the voltage for the Tray 5 Pick Motor encoder (EN101) on the Motion PCA (A2)
1. Verify that J2 is connected to the Tray 5 Distribution PCA (A101).
2. Disconnect J13 from A2.
3. Test the voltage to EN101 on A2: 5 Vdc at J13 pins 15 and 13, 14, 37, and 38 (GND) and pins 27 and 13, 14, 37, and 38 (GND).
„Motion PCA (A2) diagram" auf Seite 2308
VORSICHT! Use an ESD strap.
Is the voltage correct?
No Yes
Check the wire harness between the Motion PCA (A2) and the Tray 5 Distribution PCA (A101)
1. Check the wire harness between A2 and A101.
2. „Tray 5 wiring diagram" auf Seite 2281
1 VORSICHT!
Replace the Motion PCA (A2)
1. Replace A2.
„Motion PCA (A2)" auf Seite 710
VORSICHT! Use an ESD strap.
DEWW
Use an ESD strap.
A2.0101: Tray 5 Pick motor (M101) stall 1263