HP CM8060 Color MFP Kundendienst Handbuch Seite 1374

B0.06C1: Right-side Middle Panel LED (LED13) not lit
Initial Steps
1. „Vertical component locator" auf Seite 2372
Test the Right-side Middle Panel LED (LED13)
1. Activate LED13.
2. Verify that LED13 turns on and off.
„Vertical component locator" auf Seite 2372
TIPP: Click Subsystems, click Paper Path, and then click Vertical Transport.
Does the LED turn on and off?
No Yes
Check for problems that might cause intermittent behavior
1. Check the wire harness between the Motion PCA (A2) and the LED.
„Vertical wiring diagram" auf Seite 2301
1 2. Visually check the LED mounting and surrounding area for any obvious problems. Repair as needed.
Check the Right-side Middle Panel LED (LED13) and wire harness
1. Verify that the LED is correctly located.
„Vertical wiring diagram" auf Seite 2301
2. Check the wire harness between the Motion PCA (A2) and the LED.
Test the Right-side Middle Panel LED (LED13)
1. Activate LED13.
2. Verify that the LED turns on and off.
„Vertical component locator" auf Seite 2372
TIPP: Click Subsystems, click Paper Path, and then click Vertical Transport.
Does the LED turn on and off?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the Right-side Middle Panel LED (LED13) on the Motion PCA (A2)
1. Disconnect J10 from A2.
2. Test the voltage to LED13 on A2: 5 Vdc on J10 at pins 7B to 9B.
„Motion PCA (A2) diagram" auf Seite 2308
Is the voltage correct?
No Yes
1308 Kapitel 8 Hardware fault trees DEWW