HP CM8060 Color MFP Kundendienst Handbuch Seite 1397

No Yes
Test the voltage at the Horizontal Transport 3 sensor (SN2)
1. Verify that J9 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the sensor.
3. Test the voltage at SN2: 4.96 Vdc unblocked and blocked at pins 8A to 10A (GND) and 0.12 Vdc unblocked and blocked at
pins 9A to 10A (GND) on W15P5-W37J5.
„Horizontal component locator" auf Seite 2364
1 Is the voltage correct?
No Yes
1
Replace the Horizontal Transport 3 sensor (SN2)
1. Replace SN2.
1 2
„Horizontalsensoren" auf Seite 400
Check the wire harness between the Motion PCA (A2) and the Horizontal Transport 3 sensor (SN2)
1. Check the wire harness and connections between A2 and SN2.
„Horizontal component locator" auf Seite 2364
„Horizontal wiring diagram" auf Seite 2283
1 2. Repair as needed.
„D4.0705: Motion PCA (A2) power not good" auf Seite 1469
DEWW B1.1303: Paper jam at Horizontal Transport 3 sensor (SN2) 1331