HP CM8060 Color MFP Kundendienst Handbuch Seite 1448

1 „Final activities" auf Seite 24
Test the voltage to the IDO Output Media sensor (SN9) on the Motion PCA (A2)
1. Disconnect J5 from A2.
2. Test the voltage to SN9 on A2: 5 Vdc unblocked, 0 Vdc blocked at J4 pins 14B to 15B and 5 Vdc unblocked and blocked at pins 13B
to 15B.
„Motion PCA (A2) diagram" auf Seite 2308
VORSICHT! Use an ESD strap.
Is the voltage correct?
No Yes
Test the voltage at the IDO Output Media sensor (SN9)
1. Verify that J5 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the sensor.
3. Test the voltage at SN9: 5 Vdc unblocked, 0 Vdc blocked at pins 2B to 1B and 5 Vdc unblocked, 5 Vdc blocked at pins 3B to
1B on W96P6-W45J6.
„IDO paper path 1 wiring diagram" auf Seite 2285
1 Is the voltage correct?
1 No Yes
Replace the IDO Output Media sensor (SN9)
1. Replace SN9.
1 2 „IDO-Sensoren" auf Seite 485
Check the wire harness
1. Check the wire harness and connections between the IDO Output Media sensor (SN9) and the Motion PCA (A2).
„IDO paper path 1 wiring diagram" auf Seite 2285
1 2. Repair as needed.
„D4.0705: Motion PCA (A2) power not good" auf Seite 1469
1382 Kapitel 8 Hardware fault trees DEWW