Test the voltage at the Front Door LED (LED7)
1.
Verify that J8 is connected on the Motion PCA (A2).
2.
Disconnect the LED wire connector.
3.
Activate LED7.
4.
Test the voltage at LED7 on: 2.0 Vdc at pins 3A to 4A on W32P9-W34J9.
1
Is the voltage correct?
1
No
Yes
Replace the Front Door LED (LED7)
1
2
1.
Replace the LED.
Check the wire harness between the LED and the Motion PCA (A2)
1.
Check the wire harness between A2 and the LED.
1
„Drum wiring diagram" auf Seite 2265
Replace the Motion PCA (A2)
1.
Replace A2.
„Motion PCA (A2)" auf Seite 710
DEWW
00.06C1: Front Door LED (LED7) not lit 1187