HP CM8060 Color MFP Kundendienst Handbuch Seite 1486

C4.0201: Spit web not detected
Initial Steps
1. „Web wipe component locator" auf Seite 2373
HINWEIS: A C4.0201 error can only be declared after the web material has been replaced and the preventive maintenance counter
for the web material has been reset.
Check the web wipe cartridge for correct installation
1. Verify that the web wipe cartridge is correctly installed.
Is the web wipe cartridge correctly installed and latched?
No Yes
Check the installation of the web material
1. Check for correct web material routing and orientation.
„Web wipe component locator" auf Seite 2373
2. Verify that the web material is not pinched or damaged.
1 Is the web material correctly installed after the web material was replaced?
1 No Yes
Check for a C4.0501 error code
1. Check the Event Log for a C4.0501 error code.
1 2 Is a C4.0501 error code displayed?
1 2 No
1 2 3
Check for a D1.0201 error code
1. Check the Event Log for a C4.0501 error code. If the code is displayed, follow the troubleshooting procedures for
1 2 the code.
Verify that the web material is correctly installed
1. After the web wipe cartridge has been reinstalled and correctly latched, reset the web material preventive maintenance counter
again to force a spit web detect routine.
2. After resetting the counter, watch the spit web detect routine to verify that the spit web material moves and that the Tetris
sensor (SN58) is correctly located over the spit web.
„Web wipe component locator" auf Seite 2373
HINWEIS:
1 counter without replacing the web material.
Reinstall the web wipe cartridge
1. Reinstall the web wipe material.
1420 Kapitel 8 Hardware fault trees
Yes
„C4.0501: Web Advance encoder (EN11) stall" auf Seite 1426
By running a spit web detect routine, a certain amount of web material is used. Do not reset the web material
DEWW