HP CM8060 Color MFP Kundendienst Handbuch Seite 1345

Check the wire harness between the Tray 5 Distribution PCA (A101) and the Motion PCA (A2)
1. Check the wire harness between A101 and A2. Repair as needed.
2. If no problem is found, replace the following in order:
1) Cabling between Tray 5 and print engine.
2) A101.
3) Wire harness between A2 and the print engine bulkhead.
1 2 „Tray 5 component locator" auf Seite 2363
Replace the Motion PCA (A2)
1. Replace A2.
„Motion PCA (A2)" auf Seite 710
1 VORSICHT!
Check the following conditions:
1. Make sure that the sensor is correctly located.
2. If the sensor has a flag actuator, check that the flag actuator has free movement.
3. Clean the sensor and the surrounding area.
4. Check the wire harness between the Tray 5 Front Latch sensor (SN105) and the Motion PCA (A2).
Test the Tray 5 Front Latch sensor (SN105)
1. Manually activate SN105.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the Tray 5 Front Latch sensor (SN105) on the Tray 5 Distribution PCA (A101)
1. Test the voltage to SN105 on A101: 1.2 Vdc at pins 13B to 11B and 0.08 Vdc unblocked and 4.9 vdc blocked at pins 12B to 11B on
W103P103-A101J3.
„Tray 5 distribution PCA diagram" auf Seite 2282
VORSICHT! Use an ESD strap.
Is the voltage correct?
No Yes
DEWW
Use an ESD strap.
A2.02E1: Reattach Tray 5 1279