HP CM8060 Color MFP Kundendienst Handbuch Seite 1301

A1.02EC: Tray 2 open
Initial Steps
1. Verify that the tray closes completely and latches securely.
2. Check for any obstructions behind the tray.
„Trays 2, 3, and 4 component locator" auf Seite 2370
Check the control panel messages
1. Open and close Tray 2 and verify that the Tray 2 open message is displayed and then not displayed on the control panel.
Is the Tray 2 open message displayed when the tray is open and then not displayed when the tray is closed?
No Yes
1 „Final activities" auf Seite 24
Check the 5, 24, and 32 Vdc LEDs on the Trays 2, 3, and 4 Controller PCA (A23)
1. Verify that the LEDs are lit.
Are the 5, 24, and 32 Vdc LEDs on A23 lit?
No Yes
Check the Tray 2 Open switch (SW9)
1. Pull out the tray.
2. Manually actuate SW9.
TIPP: Click Subsystems, click Input Trays, and then click Trays 2, 3, 4.
1 Does the switch change state?
1 No Yes
Check the paper tray leaf spring actuator for damage or misalignment
1. Check the tray leaf spring actuator for damage and correct mounting location.
1 2 ACHTUNG:
Check the control panel messages
1. Open and close Tray 2 and verify that the Tray 2 open message is displayed and then not displayed on the control
panel.
1 2 Is the Tray 2 open message displayed when the tray is open and then not displayed when the tray is closed?
No
1 2
1 2 3
Replace the tray drawer
1 2 1. Replace Tray 2.
Replace the Tray 2 Open switch (SW9)
1. Replace SW9.
„Sensoren Fächer 2, 3 und 4" auf Seite 343
1 VORSICHT!
DEWW
When checking the paper tray leaf spring be careful not to bend or damage the leaf spring.
Yes
„Final activities" auf Seite 24
Use an ESD strap.
A1.02EC: Tray 2 open 1235