HP CM8060 Color MFP Kundendienst Handbuch Seite 1495

C7.0B06: IDS system will not pressurize
Initial Steps
1. Check for ink leaks in the following areas:
1) The floor underneath the unit
2) IDS connections
3) Pens
4) Near or around the ISS (ink supply station) unit
5) Ink cartridges
HINWEIS: The typical time to pressurize five empty ink supplies is 50 seconds.
The typical time to pressurize five full ink supplies is 15 seconds.
Look for a message indicating that the lower-left door is open
1. Check the control panel for a message indicating that the lower-left door is open.
Is a message indicating that the lower-left door is open displayed on the control panel?
No Yes
Do the following actions to service the lower-left door
1. Test the Lower-left Door sensor (SN18).
2. Check the alignment and the hinges of the lower-left door.
3. Check the wire harness between SN18 and the Motion PCA (A2).
4. Clean SN18.
5. Test the voltage at SN18: 3.26 Vdc blocked, 0.15 Vdc unblocked at pins 18A to 17A and 1.18 Vdc both blocked and unblocked
at pins 16A to 17A onW32P9-W34J9.
1 6. Replace the lower-left door assembly.
Check for a broken bag
1. Open the Ink Supply Status page, and then check to see if one of the ink cartridge has a broken bag.
Does one of the ink cartridges have a broken bag?
No Yes
„C7.0B08: IDS leak detected" auf Seite 1434
1
Pressurize the IDS for 50 seconds
1. Pressurize the IDS for 50 seconds.
Did the IDS pressurize between 39.65 and 43.09 kPa (5.75 and 6.25 PSI) in 50 seconds?
No Yes
Pressurize the IDS three times
1. Pressurize the IDS for 50 seconds three times in a row.
1
Did the IDS pressurize between 39.65 and 43.09 kPa (5.75 and 6.25 PSI) in 50 seconds each time?
1 No Yes
DEWW C7.0B06: IDS system will not pressurize 1429