HP CM8060 Color MFP Kundendienst Handbuch Seite 1330

A2.0102: Tray 5 Elevator motor (M102) stall
Initial Steps
1. Verify that the Tray 5 paper tray is level.
2. Verify that the paper is loaded correctly.
3. Verify that the paper guides are positioned correctly.
4. Check the condition of the cabling and connection between the print engine and Tray 5.
5. Verify that the elevator cables are correctly located.
6. If the elevator is at one of its limits, then manually move the tray off of the limit. Remove the Tray 5 rear cover and access the drive
gears in order to turn them to move the tray.
HINWEIS: If a servo motor is powered on, it will feel like there is a bind.
Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
Check the movement of the elevator tray
1. Open the Tray 5 top cover.
Does the elevator tray move down approximately the thickness of a single ream of paper (50 to 76 mm) (2 to 3 in)?
No Yes
Check the movement of the elevator while holding down the Tray 5 Media Door Open sensor (SN107)
1. Manually press SN107.
„Tray 5 component locator" auf Seite 2363
1 Does the elevator tray move down while you hold down SN107?
No Yes
1
1 2 „Final activities" auf Seite 24
1 „A2.02C2: Elevator does not go all the way to the bottom" auf Seite 1274
Check for a tray overfull message
1. Check the control panel for a tray 5 overfilled message.
HINWEIS: Ensure the Tray 5 Stack Height sensor (SN104) is straight up and down and not twisted after adjusting and securing the
sensor. Also test the alignment of the pick arm actuator to the sensor and ensure the pick arm actuates the sensor.
Is there a tray overfull message on the control panel?
No Yes
1 „A2.02E5: Tray 5 overfilled" auf Seite 1287
1264 Kapitel 8 Hardware fault trees DEWW