HP CM8060 Color MFP Kundendienst Handbuch Seite 1353

A2.02E5: Tray 5 overfilled
Initial Steps
1. Verify that Tray 5 is level.
„Tray 5 component locator" auf Seite 2363
HINWEIS: Set DVM to the appropriate range for the voltage.
HINWEIS: If the stack height calibration was recently done, check the pick arm height sensor in CDFT for proper actuation.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Check the Tray 5 Elevator Lower Limit sensor (SN110)
1. Manually activate SN110.
HINWEIS: If the Tray 5 elevator tray is touching the sensor, manually move the tray off of the sensor.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the state of the sensor change?
No Yes
1 „A2.0102: Tray 5 Elevator motor (M102) stall" auf Seite 1264
Check the following conditions
1. Make sure that the sensor is correctly located.
2. Clean the sensor and the surrounding area.
3. Check the wire harness between the Tray 5 Elevator Lower Limit sensor (SN110) and the Motion PCA (A2).
Check the Tray 5 Elevator Lower Limit sensor (SN110)
1. Manually activate SN110.
HINWEIS: If the Tray 5 elevator tray is touching the sensor, manually move the tray off of the sensor.
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the Tray 5 Elevator Lower Limit sensor (SN110) on the Tray 5 Distribution PCA (A101)
1. Disconnect J3 on A101.
2. Test the voltage to SN110 on A101: 4.91 Vdc blocked and unblocked at pins 16B to 14B and 0.01 Vdc unblocked, 4.92 Vdc blocked
at pins 15B to 14B on W103P103-A101J3.
„Tray 5 distribution PCA diagram" auf Seite 2282
VORSICHT! Use an ESD strap.
Is the voltage correct?
No Yes
DEWW A2.02E5: Tray 5 overfilled 1287