HP CM8060 Color MFP Kundendienst Handbuch Seite 1450

1 „Final activities" auf Seite 24
Test the voltage to the IDO Output 1 sensor (SN15) on the Motion PCA (A2)
1. Disconnect J5 from A2.
2. Test the voltage to SN15 on A2: 5 Vdc unblocked and blocked at J5 pins 7B to 9B and 5 Vdc unblocked, 0 Vdc blocked at pins 8B to
9B.
„Motion PCA (A2) diagram" auf Seite 2308
VORSICHT! Use an ESD strap.
Is the voltage correct?
No Yes
Test the voltage at the IDO Output 1 sensor (SN15)
1. Verify that J5 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the sensor.
3. Test the voltage at SN15: 5 Vdc unblocked, 0 Vdc blocked at pins 8B to 7B and 5 Vdc unblocked at pins 9B to 7B on W96P6-
W45J6.
„IDO paper path 1 wiring diagram" auf Seite 2285
1 Is the voltage correct?
1 No Yes
Replace the IDO Output 1 sensor (SN15)
1. Replace SN15.
1 2 „IDO-Sensoren" auf Seite 485
Check the wire harness
1. Check the wire harness and connections between the IDO Output 1 sensor (SN15) and the Motion PCA (A2).
„IDO paper path 1 wiring diagram" auf Seite 2285
„Motion PCA (A2) diagram" auf Seite 2308
1 2. Repair as needed.
„D4.0705: Motion PCA (A2) power not good" auf Seite 1469
1384 Kapitel 8 Hardware fault trees DEWW