HP CM8060 Color MFP Kundendienst Handbuch Seite 1451

B2.1307: Paper jam at IDO Output 2 sensor (SN12)
Initial Steps
1. Check for obstructions in the paper path.
2. Check the condition of the paper.
„IDO component locator" auf Seite 2365
Check the alignment of the engine to the finisher.
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Determine if the last print job was a duplex job
1. Ask the customer is the last print job was a duplex job.
Was the last print job was a duplex job?
No Yes
„B2.03C1: IDO Diverter solenoid (SOL2)" auf Seite 1361
1
Test the IDO Output 2 sensor (SN12)
1. Manually activate SN12.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
1 „B2.0106: IDO Output motor (M11) stall" auf Seite 1350
Check the following conditions
1. Verify that the sensor is correctly located.
2. Verify that all of the idler rollers are correctly seated and that the drive roller surfaces are free of defects.
3. Clean the sensor and the surrounding area.
4. If the sensor has a flag actuator, check that the flag actuator has free movement.
5. Check the wire harness between the IDO Output 2 sensor (SN12) and the Motion PCA (A2).
6. Manually activate SN12.
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
1 „Final activities" auf Seite 24
DEWW B2.1307: Paper jam at IDO Output 2 sensor (SN12) 1385