HP CM8060 Color MFP Kundendienst Handbuch Seite 1409

B2.0104: IDO Media Eject motor (M13) stall
Initial Steps
1. „IDO component locator" auf Seite 2365
HINWEIS: If a servo motor is powered on, it will feel like there is a bind.
Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Test theIDO Media Eject motor (M13)
1. Open the IDO.
2. Turn on M13.
Watch for the media eject fingers to cycle in and out.
TIPP: Click Subsystems, click Paper Path, and then click IDO Motors.
Does the motor turn and do the media eject fingers cycle in and out?
No Yes
Check the media eject assembly and wiring
1. Visually check the media eject mechanism and wiring for damage, burrs on ends of media eject fingers, and burrs on upper
media eject guide.
2. Repair as needed.
1 „IDO component locator" auf Seite 2365
Check the IDO Media Eject Motor encoder (EN17) count
1. Open the IDO.
2. Run IDO Media Eject motor (M13).
„IDO component locator" auf Seite 2365
TIPP: Click Subsystems, click Paper Path, and then click IDO Motors.
Does the encoder count change?
No Yes
Check the mechanism for binding or damage
1. Check the IDO Media Eject motor (M13) for binding or damage.
„IDO component locator" auf Seite 2365
1 2. Repair as needed.
Test the voltage to the IDO Media Eject motor (M13) on the Motion PCA (A2)
1. Test the voltage to M13 on A2: 5 Vdc at J14 pins 5 to 14.
„Motion PCA (A2) diagram" auf Seite 2308
Is the voltage correct?
DEWW B2.0104: IDO Media Eject motor (M13) stall 1343