HP CM8060 Color MFP Kundendienst Handbuch Seite 1453

B2.1308: Paper jam at IDO Duplex Staging sensor (SN11)
Initial Steps
1. Check for obstructions in the paper path.
2. Check the condition of the paper.
„IDO component locator" auf Seite 2365
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Determine if the last print job was a duplex job
1. Ask the customer is the last print job was a duplex job.
Was the last print job was a duplex job?
No Yes
1 „B2.03C1: IDO Diverter solenoid (SOL2)" auf Seite 1361
Test the IDO Duplex Staging sensor (SN11)
1. Manually activate SN11.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
1 „B2.0105: IDO Duplex motor (M12) stall" auf Seite 1346
Check the following conditions
1. Verify that the sensor is correctly located.
2. Verify that all of the idler rollers are correctly seated and that the drive roller surfaces are free of defects.
3. Clean the sensor and the surrounding area.
4. If the sensor has a flag actuator, check that the flag actuator has free movement.
5. Check the wire harness between the IDO Duplex Staging sensor (SN11) and the Motion PCA (A2).
6. Manually activate SN11.
„IDO component locator" auf Seite 2365
Does the sensor state change?
No Yes
1 „Final activities" auf Seite 24
DEWW B2.1308: Paper jam at IDO Duplex Staging sensor (SN11) 1387