HP CM8060 Color MFP Kundendienst Handbuch Seite 1371

No Yes
Test the voltage at the Tray 1 Door Open sensor (SN30)
1. Verify that J10 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the sensor.
3. Test the voltage at SN30: 3.3 Vdc at pins 17B to 16B (GND) and 18B to 16B (GND) on W14P6-W36J6.
„Vertical wiring diagram" auf Seite 2301
1
Is the voltage correct?
No Yes
1
Replace the Tray 1 Door Open sensor (SN30)
1. Replace SN30.
1 2 „Vertikalsensoren" auf Seite 390
Check the wire harness between the Motion PCA (A2) and the Tray 1 Door Open sensor (SN30)
1. Check the wire harness and connections between A2 and SN30.
„Vertical wiring diagram" auf Seite 2301
„Vertical component locator" auf Seite 2372
1 2. Repair as needed.
„D4.0705: Motion PCA (A2) power not good" auf Seite 1469
DEWW B0.02E1: Close right-side upper panel 1305