HP CM8060 Color MFP Kundendienst Handbuch Seite 1465

Test the voltage at the Drum Illumination 2 LED (LED9)
1. Verify that J8 is connected on the Motion PCA (A2).
2. Disconnect the wire connector from the LED.
3. Test the voltage at LED9: 0 Vdc unblocked, 2.93 Vdc with the LED on at pins 2B to 1B on W32P9-W34J9.
1 Is the voltage correct?
No Yes
1
Replace the Drum Illumination 2 LED (LED9)
1 2 1. Replace LED9
Check the wire harness between the Motion PCA (A2) and the Drum Illumination 2 LED (LED9)
1. Check the wire harness between A2 and LED9. Repair as needed.
1 „Drum wiring diagram" auf Seite 2265
Replace the Motion PCA (A2)
1. Replace A2.
„Motion PCA (A2)" auf Seite 710
DEWW C1.06C2: Drum Illumination 2 LED (LED9) not lit 1399