HP CM8060 Color MFP Kundendienst Handbuch Seite 1259

A0.03A1: Failed to pick from Tray 1, and then recovered
Initial Steps
1. „Tray 1 component locator" auf Seite 2355
HINWEIS: Ensure the wiring to the Tray 1 Media sensor (SN27) is not blocking the SN27 actuator. If so install print engine (PE) tag
3.
Check the preventive maintenance counter for the Tray 1 pick roller and separation pad
1. Check the PM counter to determine if the roller and separation pads are due for replacement.
„Tray 1 component locator" auf Seite 2355
Are the pick roller and separation pads due for replacement?
No Yes
Perform preventive maintenance
1. Replace the Tray 1 pick roller and the separation pad.
1 2. Reset the preventive maintenance counter.
Check the following conditions
1. Check the condition of the paper used in Tray 1.
2. Verify that the paper-width guide touches the edge of the paper stack.
3. Verify that the paper loaded in Tray 1 is within the product specifications.
4. Load fresh paper into Tray 1.
5. Pick 100 sheets of paper.
Was an A0.03.A1 warning declared?
No Yes
Clean the pick roller and separation pad
1. Clean the pick roller and the separation pad with a damp cloth. Use water to wet the cloth.
2. Load fresh paper into Tray 1.
3. Pick 100 sheets of paper.
1 Was an A0.03.A1 warning declared?
No Yes
1
1 2 „A0.1301: No pick Tray 1" auf Seite 1196
1 „Final activities" auf Seite 24
„Final activities" auf Seite 24
DEWW A0.03A1: Failed to pick from Tray 1, and then recovered 1193