HP CM8060 Color MFP Kundendienst Handbuch Seite 1419

B2.02E1: Close left-side lower panel
Initial Steps
1. „IDO component locator" auf Seite 2365
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Test the Left-side Lower Panel sensor (SN14)
1. Manually activate SN14.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
Service the left-side lower panel
1. Check the alignment of the left-side lower panel to the Left-side Lower Panel sensor (SN14).
1 2. Check the left-side lower panel hinges.
Check the following
1. Verify that the sensor is correctly located.
2. Clean the sensor and the surrounding area.
3. If the sensor has a flag actuator, check that the flag actuator has free movement.
4. Check the wire harness between the Left-side Lower Panel sensor (SN14) and the Motion PCA (A2).
„IDO component locator" auf Seite 2365
„IDO H-bar wiring diagram" auf Seite 2287
Test the Left-side Lower Panel sensor (SN14)
1. Manually activate SN14.
TIPP: Click Subsystems, click Paper Path, and then click IDO Sensors, Solenoids, LEDs.
Does the sensor state change?
No Yes
„Final activities" auf Seite 24
1
Test the voltage to the Left-side Lower Panel sensor (SN14) on the Motion PCA (A2)
1. Disconnect J5 from A2.
2. Test the voltage to SN14 on A2: 3.16 Vdc blocked, 0.20 Vdc unblocked at J5 pins 14A to 15A and 0 Vdc both blocked and unblocked
at pins 13A to 15A.
„IDO H-bar wiring diagram" auf Seite 2287
VORSICHT! Use an ESD strap.
Is the voltage correct?
DEWW B2.02E1: Close left-side lower panel 1353