HP CM8060 Color MFP Kundendienst Handbuch Seite 1364

A2.1302: Paper jam at Tray 5 Media 2 sensor (SN103)
Initial Steps
1. Check for obstructions in the paper path.
2. Check the condition of the paper.
HINWEIS: Set DVM to the appropriate range for the voltage.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
ACHTUNG: Do not use the frame as ground.
Test the Tray 5 Media 2 sensor (SN103)
1. Manually activate SN103.
„Tray 5 component locator" auf Seite 2363
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
„Final activities" auf Seite 24
1
Check the following conditions
1. Verify that the sensor is correctly located.
2. Verify that all of the idler rollers are properly seated and that the drive roller surfaces are free of defects.
3. Clean the sensor and the surrounding area.
4. If the sensor has a flag actuator, check that the flag actuator has free movement.
5. Check the wire harness between the Tray 5 Media 2 sensor (SN103) and the Motion PCA (A2).
„Tray 5 wiring diagram" auf Seite 2281
Test the Tray 5 Media 2 sensor (SN103)
1. Manually activate SN103.
„Tray 5 component locator" auf Seite 2363
TIPP: Click Subsystems, click Input Trays, and then click Tray 5.
Does the sensor state change?
No Yes
„Final activities" auf Seite 24
1
1298 Kapitel 8 Hardware fault trees DEWW