HP CM8060 Color MFP Kundendienst Handbuch Seite 1289

A1.02E1: Tray 2 empty
Initial Steps
1. Verify that the tray has paper. If not, load the tray with paper.
VORSICHT! Be careful when working around electricity.
Moving parts can cause injury.
Test the Tray 2 Empty sensor (SN45)
1. Open Tray 2.
2. Reach inside Tray 2, and then reach upwards to the pick arm and toggle the SN45 actuator on the pick arm.
„Trays 2, 3, and 4 component locator" auf Seite 2370
3. Check if the SN45 actuator has popped out of its holder.
4. Check SN45 for dust or paper debris. Clean as needed.
TIPP: Click Subsystems, click Input Trays, and then click Trays 2, 3, 4.
Does the sensor state change?
No Yes
Repair or align the tray
1. Repair or align the tray.
1 „Trays 2, 3, and 4 component locator" auf Seite 2370
Check another tray paper empty sensor
1. Open a different tray.
2. Reach inside the tray, and then reach upwards to the pick arm and toggle the tray paper empty sensor actuator on the pick arm.
TIPP: Click Subsystems, click Input Trays, and then click Trays 2, 3, 4.
Does the other paper empty sensor change state?
No Yes
Switch the cables on Trays 2, 3, and 4 Controller PCA (A23)
1. Disconnect the Tray 3 cable from J7 on A23.
2. Disconnect the Tray 2 cable from J6 on A23.
3. Connect the Tray 2 cable to J7 on A23.
4. Toggle the Tray 2 Empty sensor (SN45). This sensor is now detected as the Tray 3 Empty sensor (SN49).
„Trays 2, 3, and 4 assembly wiring diagram" auf Seite 2296
„Trays 2, 3, and 4 component locator" auf Seite 2370
HINWEIS:
connectors for troubleshooting purposes.
VORSICHT!
TIPP: Click Subsystems, click Input Trays, and then click Trays 2, 3, 4.
1 Does the sensor state change?
DEWW
A23 connectors J10 (Tray 4), J7 (Tray 3), and J6 (Tray 2) are identical. Cables can be swapped between
Use an ESD strap.
A1.02E1: Tray 2 empty 1223